Kegco Scratch & Dent - Kegco K309X-1 Full Size Digital Kegerator - Black Cabinet with Black Stainless Steel Door

PLEASE NOTE: Unless otherwise specified, the images shown are not the particular unit being sold.

The Kegco K309X-1 Digital Single Faucet Beer Dispenser is a beautiful freestanding kegerator that boasts digital functionality. This Kegco K309X-1 Kegerator has many of the same high quality features and attractive styling that you have come to expect from Kegco kegerators, like a removable, easy-to-clean built-in drip tray, a chrome guard rail that helps prevent your glasses from sliding off of the top, and easy rolling casters that allow you to move the kegerator with ease. In addition, a blue LED digital display and digital temperature controls allow you to monitor your specific temperature setting and adjust it easily with the push of a button.

The Kegco K309X-1 has been designed with a matte black finish and a sleek black stainless steel door for a modern look that complements any decor. Black stainless steel is a unique black-graphite tone that resists more smudges, fingerprints, water spots, and streaks than standard stainless steel. Most stainless steel surfaces do not have a fingerprint-resistant finish and will need special polish to keep them looking new. Black stainless steel can be easily cleaned with a damp cloth followed by a soft towel, making it easy to keep clean without requiring special polish.

---

Digital Temperature Control

Say no to a manual dial and enjoy this digital temperature control. Thanks to the digital display, you can easily view an accurate reading of your kegerator's internal temperature in Fahrenheit or Celsius. Where a manual dial would require you to guess the approximate temperature you were adjusting, this kegerator features intuitive up and down controls that can adjust the temperature in 1 degree increments. The K309X-1's temperature can be set as low as 32°F or as high as 75°F.

---

Wide Enough Temperature Range to Dispense or Ferment

Kegco's K309X Series utilizes fan forced cooling to ensure even, consistent cooling throughout the cabinet and to give you one of the coldest temperature ranges of any beer refrigerator on the market. Set the temperature as low as 32 degrees to dispense your delicious ice cold brew, or set it high enough to use it as a fermentation chamber.

---

Large Interior

This kegerator's spacious interior easily accommodates any full size keg (including Coors Kegs, Miller Kegs, and rubber kegs!), as well as up to two 5-Gallon D System kegs or up to three 5-Gallon Cornelius Ball Lock Home-Brew Kegs. This allows you to tap one keg while keeping two more cool and ready to dispense. If you are using the keg cooler as a fermentation chamber, it will fit a 6 gallon bucket or carboy with ease.

---

Deep Chill Function

The Deep Chill function quickly cools your warm beer so you can have more time to enjoy refreshing cold home-brew beer! A simple push of the Deep Chill button causes the compressor to kick in for up to 24 hours to cool your keg to the desired temperature. Press the button again, and the kegerator is returned to its normal operation.

---

Converts to a Refrigerator with 2 Shelves

Only have a pony size keg? Not a problem! Not only can this multi-purpose kegerator be used for dispensing and fermentation, but it also comes with two adjustable shelves that allow you to convert it into an all-refrigerator, providing extra refrigerated storage for food and beverages. The shelves can be spaced far enough apart to hold 2-liter bottles and gallon jugs, and you can even store wine thanks to the wide temperature range.

---

Locking Casters Provide Mobility

Invite your guests over to enjoy delicious kegged beer in any room of your home! The K309X-1's easy-roll casters allow you to bring the kegerator right to them. These casters can be locked down once the kegerator is in position, so it won't roll away again until you need it to.

---

These keg beer dispensers have all the equipment you'll need to dispense a delicious glass of cold draft beer. The single tap draft beer dispensing system includes a Draft Tower with one Faucet, a CO₂ Cylinder, a Regulator, and a Keg Coupler, which can all be customized for a setup that's just right for you.

* - Letting the Deep Chill function run for the full 24 hours may result in freezing of the keg.

Important information regarding Prop. 65 for CA residents.

• MDK-309X-01 Keg Beer Refrigerator with Single Faucet Dispense System
• Includes a brand new aluminum 5 lb. Aluminum Co2 Tank
  This Tank is produced from high strength aluminum alloy 6061-T6. This is superior to a steel tank because it will not rust. The service pressure is up to 1800 PSI/124 BAR with a test pressure of 3000 PSI/207 BAR. These cyldiners are stamped with required U.S. Department of Transportation and Transport Canada Markings. The 320 Valves are CGA approved, and have a male thread for Co2 Regulators. Average fill good for 5-6 Kegs depending upon your fill. (5.5" diameter, 18.25" Height).
• Includes Single Gauge Co2 Regulator
  This Regulator works with any Co2 Tank with a CGA-320 valve. The single gauge measures PSI indicating how much Co2 pressure is inside the keg. Adjustable output pressure 0-60 psi. 3000 psig Max Primary Inlet. 60 psig Safety Relief Valve R82. Female CGA-320 connection. Ball valve outlet w/ 5/16" OD Hose Barb connection. Total ports = (2) Primary 1/4" FNPT ports, (2) Secondary 1/4" FNPT ports. UL Listed, Compressed Gas Regulator - for use w/ Air, Co2 and Inert Gases.
• Includes 5 feet of 5/16 Inch I.D. Blue Air Line Assembly with 2 Snap Clamps
  The standard length is 5 feet of 5/16" I.D. Blue Air/Co2 Tubing made of Thermoplastic Vinyl Hose (Super Vinyl). This tubing will not rot, swell or dry out and is unaffected by normal cleaning compounds. This air line assembly comes with two Plastic Snap Clamps with a reusable clamp design.
• Includes D system Lever Handle Keg Coupler which can Tap all Domestic Kegs
  This is a Commercial Grade Lever Handle Keg Coupler that works with all American "D" System Sankey Kegs. This coupler features a 55-psi pressure relief valve and a nickel-plated forged brass body. To tap a keg all you have to do is pull out and then down on the lever handle to properly couple the keg. This Keg Coupler can be swapped out to a Home Brew Coupler for no additional cost.
• Includes a 3" Diameter Chrome Plated Metal Draft Tower
  The Tower is a commercial grade Single Column, Single Faucet, 3" Diameter, Chrome Plated Metal Draft Tower. This Tower comes complete with a chrome plated faucet with brass lever and 5 Feet of 3/16 Inch I.D. Clear Beer Tubing that ends in a Nozzle & Hex Nut Assembly that connects to all standard keg couplers. This Tower is mounted using the gasket and four screws that are included.
• All dispensing accessories are UL recognized components
• Converts to refrigerator 2 full-width wire shelves
• Large enough to hold all full size kegs (Including Coors, Miller and many additional brands)
• Holds: 1/2 barrels / Full Size Kegs (15.5gal), 1/4 barrels / Ponies (7.75gal) and 1/6 barrels (5gal)
• Matte black cabinet with black stainless steel door
• Black Stainless door has a protective film on it to prevent scratches during shipment. You can peel the film off once the kegerator is set up.
• Digital temperature control keeps temperature in range of 32°F-75°F
• Maximum Ambient Temperature: 100 degrees Fahrenheit
• Minimum Ambient Temperature: The lowest temperature you want to store your kegs at. The unit does not have a heater, so if the ambient temperature is lower than the set temperature, the internal temperature will match the external temperature.
• A perfect option for dispensing beer, soda, kombucha or wine
• Deep Chill function to quickly cool down warm keg
• Easy roll casters for mobility
• Removable built-in drip tray with grill to collect spills
• Chrome guard rail to protect your mugs and glasses from sliding off
• Stainless steel interior floor mat for long lasting durability and easy glide of beer keg
• 25% more energy efficient design saves you money each month!
• Plugs into standard home outlet
• UL Listed

Warranty Information:

• 1 Year Parts and Labor
• 5 Years on Compressor (parts only)

This kegerator can fit one Full Size, Pony, or Quarter Slim Keg, two 5 gallon commercial kegs along with one 5 gallon home brew keg or up to three 5 gallon home brew kegs.